Mounting Of Front Body On Rear Body - Nikon D60 Repair Manual

3. Mounting of Front body on Rear body

・Pass the wires of the relay-PCB through behind the main condenser, and assemble the front body into the rear
body.
・Tighten four screws (#624) in the order from
SB-PCB
Bottom base plate unit
・Mount the bottom base plate unit (#B66) so that [#135] comes in front, and
tighten two screws (#691) and five screws (#616) in the order from
④
#691
①
Main condenser
Do NOT let wires
mount on the coil.
③
②
#624×4
①
Direction for positioning
#616×5
⑤
#135
①
- Ａ  ･
to .
④
④
to
① ⑦
⑦ ⑥
Direction for
positioning
②
-
logo_Q0650_forGraphic
071004_Gdesign_ito
INC
VBA21001-R.3753.A
The wire that is connected
from the relay-PCB must not
mount on the other two wires.
.
#691
③
FPC must NOT
mount on this.
Bottom base plate unit
(#B66)