Ae Inspection And Adjustment; Ae Accuracy Inspection And Adjustment; "Battery Check" Inspection; Af Inspection And Adjustment - Nikon D200 Repair Manual

AE inspection and adjustment

① AE CCD alignment inspection and adjustment (ref. Page A28for details）

② AE accuracy inspection and adjustment

③ Aperture accuracy inspection
④ M1/8000 Accuracy inspection and adjustment
⑤ Adjustment for battery check level (Use the battery tool (J15423) and stabilized power supply.）
* Check & Adjust an out put of Built-in Speed light,after assembling until Rear cover.
⑥ Built-in SB flash inspection and adjustment
〔Tools required〕ref. Page A38.
・AE accuracy inspection and adjustment
For this camera, the AE shift amount, which is fundamental for other lenses, is adjusted by using the AF28/
2.8D lens.
Check in advance, by "INSPECTION for AF28mm/1:2.8D LENS." on the main menu, whether the
adjustment AF28/2.8 D lens is available.
When checking the lens, measure by using the reference body (used for the shooting image adjustment, too),
using the adjustment AF50/1.4D lens, and using the adjustment AF28/2.8D lens.
When inspecting and adjusting the AE accuracy, make an adjustment by combining the adjustment AF50/
1.4D lens, which was confirmed by "INSPECTION for AF28mm/1:2.8D LENS." and the adjustment AF28/
2.8D lens.
・"Battery check" inspection
When the battery tool (J15423) is connected, the indications of the outer LCD of this camera disappear. After
adjusting "Battery check", inspect by the software by powering to camera at 7.8V.
・Built-in SB flash inspection and adjustment
Set the distance between camera and flash meter to 1 m, and inspect and adjust the light volume of the built-in
SB. (ref. adjustment software for details)

AF inspection and adjustment

Note: When using the adjustment software for the first time, prepare 3 cameras of D200 and measure by
"WRITING OF AF ADJ. LENS OFFSET VALUE" on the main menu.
① AF accuracy inspection and adjustment (Make all the following adjustments.)
② YAW, PITCH inspection and adjustment
③ LARK adjustment (inc. CCD output adjustment)
④ AF shift adjustment
〔Tools required〕
1. When adjusting for all adjustment items
ref. Page A38.
2. When inspecting AF accuracy
① AF adjustment lens (J18266)
② AF adjusting tool (J15259）
③ Lens holder for F4 (J15280)
④ AF chart（J18344）
⑤ Chart illuminator for AF（J15264）
3. When adjusting YAW, PITCH
YAW, PITCH tool（J18230）
4. When adjusting LARK
The above tool when inspecting AF accuracy
In "AF shift adjustment", the distance from the bayonet reference plane to the imaging area (CCD) is calculated
by the actual shot photo, and its error is recorded in EEPROM as compensation amount, and adjusted.
- Ａ42 ･ -
INC
VBA13001-R.3677.A