Chapter 2. Installation
2.1 Introduction
This chapter explains the installation of the benchtop and wall-mount versions of the Optica, the various sensors used
with the system and the I/O and power wiring. To install your Optica, refer to the instructions and drawings for your
specific configuration:
•
- see "Benchtop Optica Installation" on page 7
Benchtop
•
- see "Wall-Mount Optica Installation" on page 12
Wall-Mount
WARNING! To ensure the safe operation of this unit, you must install and operate the Optica as
described in this manual. In addition, be sure to follow all applicable safety codes and regulations for
installing electrical equipment in your area.
2.2 Benchtop Optica Installation
2.2.1 Mounting the Benchtop Optica
The Optica benchtop dimensions are shown in Figure 5 below. Two feet on the bottom of the case can be unfolded to
raise up the front for easier viewing, if desired.
*Add .75" (19 mm)
for Feet
6.5*
(165)
Dimensions =
Optica™ Operator's Manual
13.5
(343)
inches
(mm)
Figure 5: Optica Benchtop Dimensions
Chapter 2. Installation
13
(330)
7