Appendix F. Automatic Balance (For Earlier Software Versions); Programming Automatic Balance For A Vga Optica; Programming Automatic Balance For A 4X40 Optica - GE Optica Operator's Manual

Appendix F. Automatic Balance (for earlier software versions)

F.1

Programming Automatic Balance for a VGA Optica

Note: For Optica Analyzers with software version 1.4.1a or later, see "Automatic Cleaning and Balance Function"
on page 47.
Item
Interval Set how often the automatic balance takes place.
Type Set the type of balance (see "Sensor Balancing" on page 36).
Status Set whether the balance will take place.
Track/Hold Set whether the display, analog outputs, and alarms will track the
sensor condition during a cleaning cycle, or hold the last process
reading. (Serial outputs always hold the process reading).
F.2

Programming Automatic Balance for a 4x40 Optica

Note: For Optica Analyzers with software version 1.4.1a or later, see "Automatic Cleaning and Balance Function"
on page 47.
Setting
Interval Set how often the balance takes place.
Type Set the type of balance (see "Sensor Balancing" on page 36).
Enable Set whether the balance will take place.
Analog Output Set whether display, analog outputs and alarms will track the sensor
Tracking condition during a cleaning cycle, or hold the last process reading.
(Serial output will always track the process reading.)
Optica™ Operator's Manual
Table 36: Automatic Balancing Options
Function
Table 37: Automatic Balancing Options
Description
Appendix F. Automatic Balance (for earlier software versions)
Enter the interval in minutes
(60 minutes minimum).
Auto, PACER
Enabled, Disabled
Track, Hold
Enter the interval in minutes
(60 minutes minimum).
Auto, PACER
Enabled, Disabled
Track, Hold
Available Options
Available Options
103