Wiring The Wall-Mount Optica - GE Optica Operator's Manual

2.3.2 Wiring the Wall-Mount Optica

All connections to the wall-mount unit are made through the panel at the bottom of the case as shown in Figure 12 and
Figure 13below. Any I/O cabling is brought into the unit through a gland at the lower left of the case and connects to
the terminal blocks on the left side of the case. Wiring for these connections is shown in Figure 15 on page 14. The
dew point sensor and temperature sensor cable connectors are located near the center of this panel.
Gland for
I/O Wiring
Optional Ethernet
LAN Connector
Figure 13: Wall-Mount Bottom Panel (viewed from bottom of Case)
Optica™ Operator's Manual
I/O Terminal Blocks
I/O Cable Gland
Ethernet LAN Connector
Serial Port
Temperature Sensor
Dew Point Sensor
AC Wiring Terminal Blocks
AC Power Input Gland
Figure 12: Wall-Mount Wiring Entrance Locations
Serial Port
COM
INPUT
LAN
Temperature Sensor
Dew Point Sensor
TEMP
DEW POINT
AC LINE
115/230 VAC 50-60 Hz
4 ASB 250V TYPE T
Chapter 2. Installation
Gland for
AC Power
Wiring
13