Table of Contents
Advertisement
Getting Ready
5
Set the power switch of the copier to "O", then "I" to restart the copier.
Specifying the DNS Configuration
1
From the "NETWORK SETTING"
menu in the Utility mode, press the
[4] key on the 10-key pad to select
"DNS CONFIG".
2
Press the
select "DISABLE" or "ENABLE",
and then press the [YES] key.
❍
If "DISABLE" is selected, the NETWORK SETTING screen
appears.
❍
If "ENABLE" is selected, the screen for entering the IP address of
the DNS server appears. (Go to step 3.)
3
Using the 10-key pad, enter the IP
address for the DNS server.
4
Press the [YES] key.
The NETWORK SETTING screen appears. To register settings in the
copier, the copier must be turned off, then on again.
5
While the NETWORK SETTING screen is displayed, press the [NO]
key or [AUTO RESET] key so that the message "PLEASE RE-START
POWER SUPPLY OFF/ON" appears.
6
Set the power switch of the copier to "O", then "I" to restart the copier.
Specifying the Gateway Transmission Setting
1
From the "NETWORK SETTING"
menu in the Utility mode, press the
[5] key on the 10-key pad to select
"GATEWAY TX".
2
Press the
select "DISABLE" or "ENABLE",
and then press the [YES] key.
The NETWORK SETTING screen appears.
IF-118
and
keys to
and
keys to
3
3-11
Advertisement
Table of Contents
