Konica Minolta IF-118 User Manual page 36

Getting Ready
4
Press the
select "AUTO" or "SPECIFY", and
then press the [YES] key.
❍
If "AUTO" is selected, the IP address is automatically acquired
from the DHCP server. The NETWORK SETTING screen appears.
❍
If "SPECIFY" is selected, the screen for entering the IP address
appears. (Go to step 5.)
Note
"AUTO" is only available if there is a DHCP server on the network.
When "AUTO" is selected, there is no need to set the subnet mask
or gateway setting.
If a fixed IP address is being used, "IP Address in NVRAM" must
be selected in PageScope Light. Select this option from the screen
displayed after clicking "TCP/IP Configuration" in the menu on the
"Network" tab.
5
Using the 10-key pad, enter the IP
address for the copier.
❍ The illustration at the right is an
example of an IP address.
Consult your network administrator for details about these settings.
6
Press the [YES] key.
The NETWORK SETTING screen appears. To register settings in the
copier, the copier must be turned off, then on again.
7
While the NETWORK SETTING screen is displayed, press the [NO]
key or [AUTO RESET] key so that the message "PLEASE RE-START
POWER SUPPLY OFF/ON" appears.
8
Set the power switch of the copier to "O", then "I" to restart the copier.
IF-118
and keys to
3
3-9