,QVWDOOLQJ D QHZ PRGXOH
Install the new module as follows:
1. Install new module of same type.
2. Pivot the module down into place.
3. Screw-tighten the module.
4. Slide the labeling strips into the module.
Figure 10-3 Installing a new module
Lower module onto rail.
Tilt module down.
Screw the module in tightly.
Insert labeling strips.
5HPRYLQJ WKH )URQW &RQQHFWRU &RGLQJ
If you want to take a "used" front connector to wire another module, you can
remove its coding mechanism:
Simply push out the front connector coding with a screwdriver.
This upper part of the coding key must then be plugged back into the old module.
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
A5E00203919-01
P S
C P U
3
7KH ILJXUH LOOXVWUDWHV WKH GHVFULEHG VWHSV
1
4
2
0DLQWHQDQFH
10-7