Slide The Labeled Strips Into The Front Panel - Siemens S7-300 Installation Manual

 /DEHOLQJ WKH 0RGXOH ,2
,QWURGXFWLRQ
The labeling strips are used to document the assignment between inputs/outputs of
the modules and the sensors/actuators of your plant.
You must use the labeling strips, depending on the module:
Table 7-10
Signal modules (not 32-channel),
Function modules,
Communication module CP 342-2
Signal modules (32-channel)
/DEHOLQJ DQG LQVHUWLQJ ODEHOLQJ VWULSV
1. Label the strips with the addresses of the sensors/actuators.

2. Slide the labeled strips into the front panel.

Figure 7-5 Slide the labeled strips into the front panel
7LS
Templates for labeling strips are available on the Internet at
http://www.ad.siemens.de/csinfo under article ID 11978022.
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
A5E00203919-01
Assigning the labeling strips to modules
0RGXOH
P S
C P U
/DEHOLQJ VWULS
2UGHU 1R
6ES7 392-2XX00-0AA0
6ES7 392-2XX10-0AA0
:LULQJ
7-13