S7-300 Modules; Wiring - Siemens S7-300 Installation Manual

0DLQWHQDQFH
 0RGXOH UHSODFHPHQW
5XOHV IRU ,QVWDOODWLRQ DQG :LULQJ
The table below shows you points to follow when wiring, installing or removing of

S7-300 modules.

5XOHV JRYHUQLQJ
Blade width of screwdriver
Tightening torque
•
Attaching modules to the rail
•
Connecting cables
POWER OFF when replacing the
...
S7-300 operating mode when
replacing ...
Load voltage OFF when
replacing the ...
,QLWLDO 6LWXDWLRQ
The module you want to replace is still installed and wired. You want to install the
same type of module.
:DUQLQJ
Disturbances can corrupt data if you insert or remove S7-300 modules while data
is being transferred via MPI. Do not replace S7-300 modules while there is data
traffic on the MPI. If you are not certain whether or not data transfer is active on the
MPI, unplug the connector on the MPI before you replace the module.
10-4
 3RZHU VXSSO\
3.5 mm (cylindrical model)
from 0.8 N/m to 1.1 N/m
from 0.5 N/m to 0.8 N/m
Yes
–
Yes
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
 &38  60)0&3
from 0.8 N/m to
1.1 N/m
–
Yes
STOP
Yes
A5E00203919-01