,QVWDOODWLRQ
,QVWDOODWLRQ VWHSV
The steps for installing the modules are described below.
1.
Plug the bus connectors into the CPU and
signal/function/communication/interface
modules.
One bus connector is included per
module, but not for the CPU.
•
Always start at the CPU when you plug
in the bus connectors. Here, take the
bus connector of the "last" module in
the row.
•
Insert the bus connectors into the
other modules.
The "last" module is not equipped with
a bus connector.
2.
Add all modules in their specified
sequence to the rail , slide them up to
the module on the left ), then swing
them down .
3.
Manually tighten the module screws.
,QVHUW WKH NH\ &38V ZLWK NH\ VZLWFK RQO\
Once you have installed the modules, you can insert the key into the CPU mode
selector switch.
6-8
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
C P U
1
2
3
C P U
A5E00203919-01