Connecting A Pg To An S7-300 - Siemens S7-300 Installation Manual

&RPPLVVLRQLQJ
,QVHUWLQJ DQG UHPRYLQJ D PHPRU\ FDUG )(3520 LQ 32:(5 2)) 0RGH
If you remove a memory card in POWER OFF mode and insert another memory
card with identical contents, the following happens after POWER ON:
The CPU 318-2 goes into STOP mode and
requests memory reset.


5HTXLUHPHQW
The programming device must be equipped with an integrated MPI interface or an
MPI card in order to connect it to the MPI interface of your CPU.
&URVVUHIHUHQFH
For information on possible cable lengths refer to the Chapter &RQILJXULQJ &DEOH
/HQJWKV.
&RQQHFWLQJ D 3* WR DQ 6
1. Connect the programming device (PG) to the MPI interface of your CPU by
means of a preassembled PG cable  .
Alternatively, you can produce the connecting leads with PROFIBUS cable and bus
connectors yourself (refer to Chapter :LULQJ &RQQHFWLQJ %XV &RQQHFWRUV).
Figure 9-3 Connecting a PG to an S7-300
9-8
&38  EXIIHUHG
&RPPLVVLRQLQJ WKH PRGXOHV
&RQQHFWLQJ WKH 3*
PG
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
&38V  ,)0 WR  '3
The CPU switches to the mode it was in
prior to POWER OFF, that is, RUN or
STOP.
SF
SIEMENS
BUSF
DC5V
FRCE
RUN
STOP
PS CPU
MPI
1
SM
A5E00203919-01