Siemens S7-300 Installation Manual page 92

:LULQJ
 :LULQJ WKH SRZHU VXSSO\ PRGXOH DQG WKH &38
5HTXLUHPHQW
The modules are mounted on the rail.
&RQQHFWLRQ FRPE H[FHSW IRU &38  ,)0
The power supply (PS) module is supplied with a connection comb to facilitate
connection of the power supply module and the CPU.
36 DQG &38 ZLULQJ
1RWH
The PS 307 power supply module is equipped with two additional DC 24 V
connections (L+ and M) for the supply of I/O modules.
:DUQLQJ
You may come into contact with live wires if the power supply module and any
additional load power supply units are connected to the mains.
You should therefore disconnect the S7-300 from the power supply before starting
the wiring. Only use ferrules with insulating collars to press-fit onto the ends of the
cables. Once you have wired the modules, close all the front panels. You can then
switch on the S7-300 again.
7-6
S7-300 Automation System, Hardware and Installation: CPU 312IFM - 318-2 DP
A5E00203919-01