Service checks
90x.xx error
Step
Questions / actions
1
Turn the printer off, and remove the rear
shield. See
"Rear shield removal" on
page
4-7. Check the cable connections.
Are all the cable connections secure?
925.01—Fan error service check
Step
Questions / actions
1
Turn off the printer, and remove the rear
shield. See
"Rear shield removal" on
page
4-7. Unplug the fan cable at JFAN1 and
turn the printer on. Check the following
connectors:
Are the measured values correct?
Y112730-2
JFAN1
Pin
Voltage
1
+3.3 V dc
2
Ground
3
+24 V dc
Yes
Replace the controller
board. See
"Controller
board removal" on
page
4-18.
Yes
Replace the top cover
(which includes the fan).
See
"Top cover assembly
removal" on page
4-9.
No
Securely make all the
connections. POR the
printer.
No
Replace the controller
board. See
"Controller
board removal" on
page
4-18.
Diagnostic information
2-31