TPS Setup
Right or Left TPS
The value of the TPS sensor is set at manufacturing. If a sensor is replaced, enter the 32-digit hexadecimal TPS
value from the barcode next to the sensor.
To enter the value:
1.
Select TPS SETUP from Diag Menu, and press Select (
2.
Select Right or Left, and press Select (
TPS Right 1-16 or TPS Left 1-16 appears above a blinking 0 in the left position.
3.
To enter a character or digit:
a.
press
b.
Pause for several seconds without pressing any buttons. The blinking value becomes solid.
If the value is incorrect, use Back (
c.
Continue until the last value is reached.
When the last of the 16 values is entered and becomes solid, TPS Right 17-32 or
d.
TPS Left 17-32 appears.
e.
Continue entering and pausing.
4.
After the 32nd number is entered and becomes solid, the number is automatically entered.
If the number is incorrect, Checksum does not match appears, and the original screen appears to
•
re-enter the value.
If the number is correct, Saving changes to NVRAM appears.
•
Reset Color Cal
This setting allows the device to adjust the alignment of the color planes using pre-programmed default values.
To reset the programmed value:
1.
Select TPS SETUP from DIAGNOSTICS, and press Select (
2.
Select Reset Color Cal, and press Select (
Resetting appears. When the reset is complete, the screen is automatically returned to TPS SETUP.
Cal Ref Adj
Used with Reset Color Cal, which resets to a default value, Cal Ref Adj allows you to fine tune the TPS function.
To set the Cal Ref Adj:
1.
Select TPS Setup from Diag Menu, and press Select (
2.
Select Cal Ref Adj, and press Select (
3.
Select CMY or Black, and press Select (
4.
press
The values can be -8 to +8, and the default value is 0.
To cancel and return to the menus, press Back (
Reports
Main Settings Page
To print the Menu Settings Page:
1.
Select Reports from Diag Menu, and press Select (
2.
Select Menu Settings Page, and press Select (
3-22
Service Manual
to decrease or
to increase the blinking value.
to decrease or
to increase the value.
).
).
) to go back and re-enter the number.
).
).
).
).
).
).
).
).
Y112730-2