Table of Contents
Advertisement
16.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
17.
Press
18.
Scroll to Top Edge, and press
19.
Use the
Note: Pressing
20.
Press
To manually register the flatbed, perform the following steps:
1.
In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2.
Press
3.
Scroll to the Print Quick Test Page menu item.
4.
Press
5.
To view and adjust the flatbed registration, place the quick test page into the flatbed, scroll to the Copy
Quick Test Page item, and press
6.
After the quick test page copies, scroll to Flatbed, and press
7.
Scroll toLeft Edge, and press
8.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
9.
Press
10.
Scroll to Top Edge, and press
11.
Use the
Note: Pressing
12.
Press
To exit RESGISTRATION press BACK
Disable Scanner
This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on
for the new settings to take effect. To change the setting, perform the following steps:
1.
In the configuration menu, use the arrow keys to scroll to the Disable Scanner menu item.
2.
Press
3.
Use the arrow key to scroll to the desired setting. The options are Enable ADF/FB, Disable ADF/FB,
Disable ADF only, Auto Disabled.
4.
Press
5.
Press BACK
6.
Scroll to Exit Config Menu.
7.
Press
3-36
Service Manual
or
to increase or decrease the settings value.
to accept the value.
or
to increase or decrease the settings value.
moves the margin up, and pressing
to accept the value.
.
.
.
or
to increase or decrease the settings value.
to accept the value.
or
to increase or decrease the settings value.
moves the margin up, and pressing
to accept the value.
.
.
.
. The device restarts.
.
moves the margin down.
.
.
moves the margin down.
or STOP
.
.
Y112730-2
Advertisement
Table of Contents
