Table of Contents
Advertisement
Installation notes:
•
Make sure the springs are resting on the top so they can be reached once the fuser is in place.
•
When reinstalling on the right, make sure the gears mesh.
•
Be careful not to interfere with the exit sensor on the left side.
•
Reroute the cables back through their retainers.
•
When you replace a new fuser, be sure to reset the Fuser Page Count.
1.
Enter Diagnostics Menu (turn the printer off., press and hold Left (
printer on, and release the buttons when the installed memory and processor speed displays.
2.
Select Printer Setup, and press Select (
3.
Select Reset Fuser Cnt, and press Select (
Reset Fuser Cnt Reset appears on the display.
4.
Select Back (
Y112730-2
) twice, and select Exit Diags, and press Select (
).
).
) and Select (
), turn the
).
Repair information
4-27
Advertisement
Table of Contents
