Table of Contents
Advertisement
Updating the firmware using a USB thumb drive
If a USB thumbdrive is available, it can be used to update the printer firmware. Before updating the firmware,
download the zip file containing the firmware files from http://www.olinet.biz.
Warning: Before performing a firmware update on the printer, contact the technical service center or second
level of support to verify the correct firmware and keycode. The wrong firmware or wrong level of
firmware could lead to a malfunction or render the printer inoperable.
Copy the firmware files to the thumb drive. You do not need to copy the USBFlash executable to the flash
drive.
Note: A printer that is in Invalid Code mode cannot be updated from a USB thumb drive.
Note: Verify the Enable Drive and Update Code settings are enabled. These settings are in the Flash Drive
menu under the Settings Menu in the Administrative menus.
To update the printer firmware, perform the following steps:
Insert the flash drive into the USB port located on the operator panel. USB Menu: Print from USB
1.
displays.
Note: If "Print from USB" doesn't display by default, use the
the Print from USB command.
2.
Press
3.
Use the
Warning: fullnet.fls must be the first file to be updated. failure to update this file first could damage the
machine or render it inoperable.
4.
Press
5.
Press
display on the operator panel.
Warning: DO NOT TURN THE MACHINE OFF until the update is complete. When the update is
completed, the printer will automatically reboot and return to Ready.
If your flash drive is inserted into the USB port located on the operator panel, USB Menu: Print from USB
displays.
Note: If "Print from USB" doesn't display by default, use the
the Print from USB command.
6.
Press
7.
Use the
8.
Press
9.
Press
display on the operator panel.
Warning: DO NOT TURN THE MACHINE OFF until the update is complete. When the update is
completed, the printer will automatically reboot and return to Ready.
If your flash drive is inserted into the USB port located on the operator panel, USB Menu: Print from USB
displays.
Note: If "Print from USB" doesn't display by default, use the
the Print from USB command.
10.
Press
11.
Use the
12.
Press
13.
Press
display on the operator panel.
Y112730-2
Select. The flash drive's directory structure displays.
or
buttons to navigate to the fullnet.fls (also known as 1.fls) firmware file.
Select. Program Device: Yes displays.
Select. The printer will start the update process. Various status and progress messages will
Select. The flash drive's directory structure displays.
or
buttons to navigate to the updeng.fls (also known as 2.fls) firmware file.
Select. Program Device: Yes displays.
Select. The printer will start the update process. Various status and progress messages will
Select. The flash drive's directory structure displays.
or
buttons to navigate to the scanner.fls (also known as 3.fls) firmware file.
Select. Program Device: Yes displays.
Select. The printer will start the update process. Various status and progress messages will
Left or
Right buttons to navigate to
Left or
Right buttons to navigate to
Left or
Right buttons to navigate to
Diagnostic aids
3-53
Advertisement
Table of Contents
