Olivetti d-Color MF920 Service Manual page 65

Service error messages (1XX, 8XX and 9xx) (continued)
Error code
846.06
846.07
847
847.01
847.02
848
848.01
849
849.01
9xx service errors
900.xx Service
RIP Software
902.xx Service
Engine Software
903.xx Service
Engine Software
904.xx Service
Engine Software
905.xx Service
Engine Software
906.xx Service
Engine Software
Y112730-2
Description
Front calibration strip has excessive
dark area
Front magnification exceeds limits
Modem Failure
Fax Storage
Fax Storage
Modem/Config ID Mismatch
Modem/Config ID Mismatch
HD/Config ID Mismatch
HD/Config ID Mismatch
Unrecoverable RIP software error/
illegal trap.
A general engine software error.
A general engine software error.
A general engine software error.
A general engine software error.
A general engine software error.
Action
Front excessive variability for Mono, Red,
Green, or Blue. Go to "CCD service
check" on page 2-65
Rear excessive variability for Mono, Red,
Green, or Blue. Go to "CCD service
check" on page 2-65
The Configuration ID bit that describes the
device's modem doesn't match the actual
modem installed in the device.
The amount of flash storage available on
the device is too small. Note: The NAND
Flash partition can shrink as bit failures
cause blocks to be invalidated. Go to
"Format Fax Storage" on page
the issue is not fixed, replace the controller
board. Go to "Controller board removal"
on page 4-18.
The devices' flash partition is invalid or
unavailable. Go to "Format Fax Storage"
on page 3-34. If the issue is not fixed,
replace the controller board. Go to
"Controller board removal" on
page 4-18.
A device doesn't have a modem installed,
even though its Configuration ID indicates
that a modem should be present.
A device has a modem installed, but its
Configuration ID indicates that a modem
shouldn't be present.
A device doesn't have a hard drive
installed, even though its Configuration ID
indicates that a hard drive should be
present.
A device has a hard drive installed, but its
Configuration ID indicates that a hard drive
shouldn't be present.
Go to "90x.xx error" on page
Go to "90x.xx error" on page 2-31
Go to "90x.xx error" on page 2-31
Go to "90x.xx error" on page 2-31
Go to "90x.xx error" on page 2-31
Go to "90x.xx error" on page 2-31
Diagnostic information
3-34. If
2-31.
2-21