Table of Contents
Advertisement
Error codes and messages
User status and attendance messages
User status and attendance messages
User primary message Explanation
Busy
Calibrating
Close Door
Check Config ID
Check Model Name
Check Serial Num
<color> Low
Defragmenting Flash
DO NOT POWER OFF
Flushing buffer
Formatting Flash
DO NOT POWER OFF
Hex Trace
Imaging Kit
Insert Tray <x>
No Analog Phone Line
Memory Full, cannot
send faxes
Insert Duplex Page in
Tray <x>
Install Tray <x> or
Cancel job
Load <source> <custom
string>
2-6
Service Manual
Wait for the message to clear.
The printer is performing a color adjustment.
Message clears when upper and lower doors are closed.
The printer configuration ID is invalid.
Message clears when a valid model name is set.
Message clears when a valid serial number is set.
Replace the toner cartridge, and then wait for the message to clear.
The printer is performing the defragmentation operation of flash memory. Wait for the
message to clear.
Warning: Do not turn the printer off while this message appears on the display.
Wait for the message to clear.
Wait for the message to appear.
Warning: Do not turn the printer off while this message appears on the display.
This message appears between status messages and warnings. Wait for the
message to clear.
Replace the imaging kit, and then press Select (
continue printing.
This message is displayed when the printer requests the user to insert tray x before it
can continue printing the job. The printer needs to pick media from the missing tray or
the trays below it.
Tray x=Tray 1, Tray 2, Tray 3
Note: This message displays when refilling the trays during a job. Before filling tray a
tray, take the printer offline by pressing Stop
into the output bin.
The following actions can be taken:
• Insert the requested tray.
• Cancel the current job
An analog line is not detected as being plugged into the modem. If the device is in
Analog mode, this has a source of Fax. If the device is in Fax Server mode, and the
'Enable analog receive' Fax Server setting is set to 'On', this has a source of Fax
Receive. If the device is in Fax Server mode and the 'Enable analog receive' Fax
Server setting is set to 'Off', then this IR is not generated.
After a start, there is no memory to do the fax job. Attempted fax is cancelled.
Reload printed page in tray <x>. Cancel Job appears if the job can be cancelled.
Printer detects that tray <x> is missing, where x is 1 or 2. This message appears if the
job was begun, but the paper has not yet been retrieved. The tray is no longer
detected. Replace the indicated tray.
Printer does not detect media meeting the description <custom string> in <source>,
where <source> is Tray 1, Tray 2, Tray 3, Multi-Page Feeder (MP feeder), or
Envelope Feeder.
• Load the input source with the correct type and size media.
• Cancel the current job.
) to clear the message and
, and wait for pages to stop feeding
Y112730-2
Advertisement
Table of Contents
