Table of Contents
Advertisement
W.580A1 • W.68002
W.580A1
[W.580A1] Invalid memory configuration for Mirror Mode. Please correct memory configuration.
Explanation: Unsupported DIMM Population for Mirror Mode
Severity: Error
User response: Complete the following steps:
1.
If a DIMM connector error LED is lit, resolve the failure.
2.
Make sure that the DIMM connectors are correctly populated for mirroring mode, according to the service
information for this product.
W.580A2
[W.580A2] Invalid memory configuration for Sparing Mode. Please correct memory configuration.
Explanation: Unsupported DIMM Population for Spare Mode
Severity: Error
User response: Complete the following steps:
1.
Make sure that the DIMM connectors are correctly populated for sparing mode, according to the service
information for this product.
W.68002
[W.68002] A CMOS battery error has been detected
Explanation: CMOS Battery Fault
Severity: Error
User response: Complete the following steps:
1.
If the system was recently Installed, Moved, or Serviced, makesure the batter is properly seated.
2.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
3.
Replace CMOS Battery
4.
(Trained Service technician only) Replace the system board.
610
System x3650 M4 BD Type 5466: Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
