Table of Contents
Advertisement
W.3808000
[W.3808000] An IMM communication failure has occurred.
Explanation: IMM Communication Failure
Severity: Warning
User response: Complete the following steps:
1.
Reset IMM.
2.
Remove and re-install power from the system. Then reboot the entire system.
3.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
4.
Reflash UEFI Firmware.
5.
(Trained service technician only) Replace the system board.
W.3808002
[W.3808002] An error occurred while saving UEFI settings to the IMM.
Explanation: Error Updating System Configuration to IMM
Severity: Warning
User response: Complete the following steps:
1.
Use F1 Setup, Verify Settings and Save Settings to recover settings.
2.
Reset IMM.
3.
Remove and re-install power from the system. Then reboot the entire system.
4.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
5.
Reflash IMM Firmware.
6.
Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7.
(Trained Service technician only) Replace the system board.
W.3808003
.[W.3808003] Unable to retrieve the system configuration from the IMM.
Explanation: Error Retrieving System Configuration from IMM
Severity: Warning
User response: Complete the following steps:
1.
Use F1 Setup, Verify Settings and Save Settings to recover settings.
2.
Reset IMM.
3.
Remove and re-install power from the system. Then reboot the entire system.
4.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
5.
Reflash IMM Firmware.
6.
Remove and re-install CMOS battery for 30 seconds to clear CMOS contents.
7.
(Trained Service technician only) Replace the system board.
W.3808000 • W.3808003
Appendix B. UEFI/POST error codes
607
Advertisement
Table of Contents
Troubleshooting
