IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 383

806f000d-040cffff • 806f000f-220101ff
806f000d-040cffff The Drive [StorageVolumeElementName] has been added. (Drive 12)
Explanation: This message is for the use case when an implementation has detected a Drive has been Added.
May also be shown as 806f000d040cffff or 0x806f000d040cffff
Severity: Info
Alert Category: Critical - Hard Disk drive
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0162
SNMP Trap ID: 5
Automatically notify Support: No
User response: No action; information only.
806f000d-040dffff The Drive [StorageVolumeElementName] has been added. (Drive 13)
Explanation: This message is for the use case when an implementation has detected a Drive has been Added.
May also be shown as 806f000d040dffff or 0x806f000d040dffff
Severity: Info
Alert Category: Critical - Hard Disk drive
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0162
SNMP Trap ID: 5
Automatically notify Support: No
User response: No action; information only.
806f000f-220101ff The System [ComputerSystemElementName] has detected no memory in the system. (ABR
Status)
Explanation: This message is for the use case when an implementation has detected that memory was detected in
the system.
May also be shown as 806f000f220101ff or 0x806f000f220101ff
Severity: Error
Alert Category: Critical - Memory
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0794
SNMP Trap ID: 41
Automatically notify Support: No
User response: This is a UEFI detected event. The UEFI(POST) error code for this event can be found in the logged
IMM message text. Please refer to the UEFI(POST) error code in the "UEFI(POST) error code" section of the
Information Center for the appropriate user response. Firmware Error : Sys Boot Status :
367
Appendix A. Integrated management module II (IMM2) error messages