IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 251

Figure 150. Hot-swap backplane removal
6. Disconnect the cables.
v Type 1 - SATA
– Disconnect the LED signal, SATA signal and power cables from the
backplane. Make note of which cable is connected to which connector.
Figure 151. Type 1 - SATA
v Type 2 - SAS
– Disconnect the I
backplane. Make note of which cable is connected to which connector.
Figure 152. Type 2 - SAS
7. If you are instructed to return the backplane, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
2
C signal, SAS signal and power cables from the
Chapter 6. Removing and replacing components
235