IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 217

Figure 113. USB embedded hypervisor flash device installation
9. Install PCI riser-card assembly 1 (see "Replacing a PCI riser-card assembly" on
page 208).
10. Rotate the hot-swap rear hard disk drive cage down (see "Rotating the
hot-swap rear hard disk drive cage down" on page 169).
11. Install the server top cover (see "Replacing the server top cover" on page 260).
12. Reconnect the power cord and any cables that you removed.
13. Turn on the peripheral devices and the server.
Note: You will have to configure the server to boot from the hypervisor USB
drive. See "Configuring the server" on page 88 for information about enabling
the hypervisor memory key.
Chapter 6. Removing and replacing components
201