Control Panel Installation; Install The Enclosure - Bosch B9512G Installation And System Reference Manual

Control Panels
5

Control panel installation

This section explains how to mount the control panel enclosure, how to mount the control
panel into the enclosure, and provides an overview of how to wire modules to the control
panel.
Enclosure overview
Before you begin, review the overview figure:
Figure 5.1: Enclosure and control panel mounting overview
Callout ᅳ Description
1 ᅳ Mounting skirt attachment hooks (2)
2 ᅳ Module mounting three-hole pattern (4)
3 ᅳTamper switch mounting location
4 ᅳ Mounting skirt screw location (1)
5.1

Install the enclosure

Refer to Enclosures, page 107 to determine if the application requires a specific enclosure.
Installing the enclosure:
1.
2.
3.
4.
Notice!
Electromagnetic interference (EMI) can cause problems on long wire runs.
Bosch Security Systems, Inc.
Remove any knockouts prior to installing the control panel.
Mount the enclosure in the desired location. Use all enclosure mounting holes. Refer to
the mounting instructions supplied with the selected enclosure.
Pull the wires into the enclosure.
Optionally install the supplied point label chart on the inside of the enclosure door.
Installation and System Reference Guide
Callout ᅳ Description
5 ᅳ Enclosure mounting holes (5)
6 ᅳ Mounting skirt attachment holes (2)
7 ᅳ Back of the control panel mounting skirt
8 ᅳ Mounting skirt screw tab
Control panel installation | en
2016.06 | 08 | F.01U.303.996
31