18
en | Control panel installation
5
Control panel installation
This section explains how to mount the control panel enclosure, how to mount the control
panel into the enclosure, and provides an overview of how to wire modules to the control
panel.
5.1
Install the enclosure and wiring label
Refer to Enclosures, page 86 to determine if the application requires a specific enclosure.
Installing the enclosure:
1.
2.
3.
4.
Notice!
Electromagnetic interference (EMI) can cause problems on long wire runs.
1
Figure 5.1: Enclosure and control panel mounting (B10 shown)
Callout ᅳ Description
1 ᅳ Control panel wiring label
2 ᅳ Enclosure mounting holes (4)
3 ᅳ Module mounting locations (4)
2017.04 | 15 | F.01U.287.180
Remove any knockouts prior to installing the control panel.
Mount the enclosure in the desired location. Use all enclosure mounting holes. Refer to
the mounting instructions supplied with the selected enclosure.
Pull the wires into the enclosure.
Install the supplied Enclosure Wiring Label (B5512/B4512/B3512) on the inside of the
enclosure door.
2
2
Installation Manual
3
2
5
2
Bosch Security Systems, Inc.
Control Panels
3
4