Diags Menu; Wireless; Network Menu - Bosch B9512G Installation And System Reference Manual

158 en | Keypad Installer menu
B91x/B92x keypads use of Signal Strength (for RF repeaters)
1.
2.
3.
4.
5.
B93x/B94x keypads use of Signal Strength (for RF repeaters)
1.
2.
3.
4.
5.
20.3

[3] Diags menu

Use the Diagnostics menu to view available diagnostics.
20.3.1

[1] Wireless

The Wireless diagnostics are presented in two different menus for your convenience. Refer to
[3] RF Diagnostic Menu > [1] RF Points, page 156 and [3] RF Diagnostic Menu > [2] RF Repeater
Menu, page 157.
20.3.2

[2] Network menu

Use the Network menu to view information about the control panel's network connection.
Settings
B91x/B92x keypads use of Settings
1.
2.
3.
B93x/B94x keypads use of Settings
1.
2.
3.
Connection
B91x/B92x keypads use of Connection
1.
2016.06 | 08 | F.01U.303.996
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [2] RF Repeater Menu > [1] Strength.
Use [PREV] or [NEXT] to scroll though the list, and go to the repeater for which you want
to view diagnostic information, or enter the repeater number.
Press [ENTER] to view the signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check: Signal Strengths, Level, Margin.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [2] RF Repeater Menu > [1] Strength.
Use /[PREV] or /[NEXT] to scroll though the list, and go to the repeater for which
you want to view diagnostic information, or enter the repeater number and press
[ENTER].
Press [Signal] to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: Signal Strengths, Level, Margin.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Network > (choose the bus module or on-board) > [1] Settings. The keypad
scrolls through the following sub-categories, indicating the programming for: Hostname,
iPv4 Source IP, iPv6 Source IP, MAC Address.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Network > (choose the bus module or on-board) > [1] Settings. The keypad
shows the following sub-categories, indicating the programming for: Hostname, iPv4
Source IP, iPv6 Source IP, Mac Address.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Installation and System Reference Guide
Control Panels
Bosch Security Systems, Inc.