On-Board Ethernet Diagnostic Leds - Bosch B9512G Installation And System Reference Manual

Control Panels
3.
4.
For more information on using AutoIP, refer to AutoIP, page 184.
8.1.3

On-board Ethernet diagnostic LEDs

The control panel includes the following on-board LEDs to assist with troubleshooting the on-
board Ethernet connection.
Figure 8.8: On-board Ethernet and LEDs
Callout ᅳ Description
1 ᅳ LINK LED (yellow)
2 ᅳ 100BASE-T LED (green)
Refer to the following tables for information on the 100BASE-T and LINK LEDs.
Flash pattern
Tab. 8.2: 100BASE-T LED descriptions
Flash pattern
Flashing
Bosch Security Systems, Inc.
In RPS, open the control panel account and click the Connect button. From the Connect
Via drop-down list select IP Direct. Click Connect. Once connected, perform the
necessary tasks, and disconnect when finished.
Reconnect the cable used for IP communication, if applicable.
Improper installation
can be a fire hazard .
USB POWER
STATUS
USB
On Steady
Off
On Steady
Installation and System Reference Guide
B
A
L
S
I
E
N
K
T
ETHERNET
Function
Communicating at 100 Mb
Communicating at 10 Mb.
Function
Plugged into an Ethernet network.
Communication in progress.
IP communications | en 49
2016.06 | 08 | F.01U.303.996