Rf Repeater Menu > [3] Remove Repeater; Rf Diagnostic Menu > [1] Rf Points - Bosch B9512G Installation And System Reference Manual

156 en | Keypad Installer menu
5.
6.
20.2.6 [2] RF Repeater Menu > [3] Remove Repeater
In this menu, you can replace Repeater points.
Remove Repeater
B91x/B92x keypads use of Remove Repeater
1.
2.
3.
4.
5.
B93x/B94x keypads use of Remove Repeater
1.
2.
3.
4.
5.
20.2.7 [3] RF Diagnostic Menu > [1] RF Points
You can obtain certain wireless point diagnostic information using a keypad and this menu.
States (for RF points)
B91x/B92x keypads use of States (for RF points)
1.
2.
3.
4.
5.
B93x/B94x keypads use of States (for RF points)
1.
2.
3.
4.
5.
2016.06 | 08 | F.01U.303.996
Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
When the keypad shows Repeater Replaced, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Wireless > [2] RF Repeater Menu > [3] Remove Repeater. The keypad lists any
existing repeaters.
Use [PREV] or [NEXT] to scroll though the list of repeaters, and go to the repeater you
want to remove, or simply enter the repeater number.
Press [ENTER] to remove the device. The keypad removes the device and shows Repeater
Removed.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Program > [1] RF Point Menu> [3] Remove Point RFID. The keypad lists any
existing repeaters.
Use /[PREV] or /[NEXT] to scroll though the list of repeaters, and go to the repeater
you want to remove, or simply enter the repeater number.
Press [Remove] to remove the repeater. The keypad removes the device and shows
Repeater Removed.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Menu> [1] State.
Use [PREV] or [NEXT] to scroll though the list, and go to the point for which you want to
view diagnostic information, or enter the point number.
Press [ENTER] to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
When finished viewing the information, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Menu> [1] State menu.
Use /[PREV] or /[NEXT] to scroll though the list, and go to the point for which you
want to view diagnostic information, or enter the point number and press [ENTER].
Press [State] to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
When finished viewing the information, escape from the menu.
Installation and System Reference Guide
Control Panels
Bosch Security Systems, Inc.