Removal And Reinstallation Of The Operation Panel Or The Front Covers; Removal Of The Front Cover (Lower Side) - Mitsubishi FR-A800 Instruction Manual

Removal and reinstallation of the operation panel or the front covers

2.2
Removal and reinstallation of the operation
panel or the front covers
Removal and reinstallation of the operation panel
• Loosen the two screws on the operation panel.
(These screws cannot be removed.)
To reinstall the operation panel, align its connector on the back with the PU connector of the inverter, and insert the operation
panel. After confirming that the operation panel is fit securely, tighten the screws. (Tightening torque: 0.40 to 0.45 N·m)
Removal of the front cover (lower side) (FR-A820-01540(30K) or lower,
FR-A840-00770(30K) or lower)
(a)
(a) Loosen the screws on the front cover (lower side). (These screws cannot be removed.)
(b) While holding the areas around the installation hooks on the sides of the front cover (lower side), pull out the front cover (lower
side) using its upper side as a support.
(c) With the front cover (lower side) removed, wiring of the main circuit terminals and control circuit terminals can be performed.
22
INSTALLATION AND WIRING
• Press the upper edge of the operation panel while pulling
(b)
Loosen Loosen Loosen
out the operation panel.
(c)