Operating In Adverse Conditions; Premaintenance Procedures; Using The Bed Support; Removing The Full Bed - Toro Workman HD 07369 Operator's Manual

Operating in Adverse Conditions

Important: If the machine is subjected to any of the conditions listed below, maintenance should be performed
twice as frequently:
•
Desert operation
•
Cold climate operation below 0° C (32° F)
•
Trailer towing
•
Frequent operation on dusty roads
•
Construction work
•
After extended operation in mud, sand, water, or similar dirty conditions, have your brakes inspected and cleaned as soon as
possible. This will prevent any abrasive material from causing excessive wear.
Premaintenance
Procedures
Many of the subjects covered in this maintenance section
require raising and lowering the bed. The following
precautions must be taken or serious injury or death could
result.
WARNING
Before servicing or making adjustments to the
machine, stop engine, set parking brake, and
remove key from the ignition switch. Remove any
load material from the bed or other attachment
before working under a raised bed. Never work
under a raised bed without positioning the safety
support on a fully extended cylinder rod.

Using the Bed Support

Important: Always install or remove the bed support
from the outside of the bed.
1. Raise the bed until the lift cylinders are fully extended.
2. Remove the bed support from the storage brackets on
back of the ROPS panel (Figure 25).
1. Bed support
Figure 25
3. Push the bed support onto the cylinder rod, making
sure that the support end tabs rest on the end of
cylinder barrel, and on the cylinder rod end (Figure 26).
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder and insert it
into the brackets on the back of the ROPS panel.
CAUTION
Do not try to lower bed with bed safety
support on cylinder.

Removing the Full Bed

1. Start the engine. Engage the hydraulic lift lever and
lower the bed until the cylinders are loose in the slots.
2. Release the lift lever and turn off the engine.
3. Remove the lynch pins from the outer ends of the
cylinder rod clevis pins (Figure 27).
30
Figure 26
3. Bed