The Westminster Front Installation - FPI P36D-NG1 Owners & Installation Manual

PALACE™ SERIES OPTIONS
THE WESTMINSTER
1) Install the hood to The Westminster
thru the screws and tighten to secure.
Westminster Front
2) Bend tabs located at the back of The Westminster
90 degrees.
Backside of front shown.
3) Secure the bottom frame of the Front by loosening the inner screw
on the hinge brackets on both the left and right side of the fi rebox.
Slide frame in place and secure.
Hinge bracket on
bottom of fi rebox
Westminster Front
frame
62
® Front by sliding the 4 cut-outs
Cut-out in Hood
® Front upwards
B e n d t a b
upwards 90
degrees.
Left Side Shown
®
FRONT INSTALLATION
4) Slide tabs into louver brackets located on the inside top of the fi re-
box.
Bracket inside
top of fi rebox.
5) Remove existing control switch box from under fi rebox by disconnecting
wires connected to the valve at TH-TH/TP terminals and discard.
Control Box
6) Connect the ON/OFF switch wires coming from the left side of the
Front to the valve, with black hooked up to the TH/TP terminal and
red hooked up to the TH terminal.
NOTE: If fan option is not used please see step (5) of optional fan
installation for placement of fan control box.
Fan Control Box
7) For optional fan installation, see "Optional Fan Installation" sec-
tion.
8) For 2-panel & 3-panel door installation, see
Installation & 3-Panel Door Installation" sections.
FPI P36D-1 Zero Clearance Direct Vent Gas Fireplace
Tabs
Wires connected to Valve.
Valve
ON/OFF Switch Wires
"2-Panel Door