FPI P36D-NG1 Owners & Installation Manual page 40

INSTALLATION
02-54
02-51
5th Grate Tab
7) Place the bottom left front edge of Log
02-55 against the rear bracket on the
burner tray and rest the log on the cutout
on Log 02-53.
02-75
02-55
02-53
Rear Bracket
8) Place Log 02-52 between Logs 02-51 and
02-75 and on the indentation on Log 02-54.
The bottom right end sits behind the rear
grate tab.
02-52
02-51
02-54
Log indentation
40
02-54
Photo shows rear grate tab.
Log 02-51 was removed to show the
positioning of Log 02-52.
9) Sit Log 02-50 on the front left side of the
burner. Push the back of the log against the
2 front brackets with the notch on the bottom
of the log fi tting into the fi rst grate tab.
Front Brackets
02-50
02-51
Notch
Cutouts
02-75
02-50
10) Place the embers on the front of the burner
02-52
Rear
Grate
Tab
02-50
02-53
02-55
02-53
02-75
02-55
FPI P36D-1 Zero Clearance Direct Vent Gas Fireplace
tray in the places shown on the photos
below.
Place embers in these 3 locations
on the burner tray.
02-51
Do not block the burner holes in this
area adjacent to the Log 02-54
11) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end of
burner to the other). If there is any fl ame
hesitation, check that area for any blockage
of the burner ports.
12) Install fl ush glass and bay glass (if used)
as per instructions in this manual.
02-54
02-51
02-54