Integra DTR-8.8 Service Manual page 169

QQ
3 7 63 1515 0
FIRMWARE UPDATE -5
Preparation for Update (Network)
Hardware and Software
1. Personal computer(PC) with USB slot (only for preparation)
2. USB memory
3. Writing soft: the target version of "firmware.dat"
Preparation
1. Delete any folders and files in a USB memory.
2. Store "firmware.dat" in the USB memory.
Network Update Procedure
1. Power on DTR-8.8.
2. Select [NET/USB], and see "Startup.." shown for a while on Front Panel and disappear.
3. Press [NET/USB] repeatedly until "USB <No storage>" is shown.
TE
4. Load the USB memory into USB slot on Front Panel.
L 13942296513
Make sure that the connected USB memory is detected and the volume name of the USB memory is shown.
<e.g.>
5. Press and hold down [DISPLAY] button and then press [STANDBY/ON] button to show Main FW version
when the unit is powered on.
<e.g.>
6. Press [Tone -] button 4 times while the Main version is displayed. Then, Net user version will be displayed.
<e.g.>
7. Press [DISPLAY] button while Net user version is displayed. Then, the following message will appear.
8. Display "SH4APL" by using Cursors.
www
.
http://www.xiaoyu163.com
SERVER
S t a r t u p.. .
U S B 0 / 0
<N o s to ra g e >
U S B 1 / 1
o U S B s to ra g e
M a i n :
9 1 . 0 3 /0 7 7 2 3 C
N e t u s r :
0 7 7 3 1 /1 2 4 6 4 3
N E T F /W u p d a t e
R DV- 0 0 :0 0 0 0 0 0 0
N E T F /W u p d a t e
x ao u163
y
S H 4 A P L :- 7 7 0 2 p 0
i
http://www.xiaoyu163.com
2 9
8
Q Q
3 6 7 1 3 1 5
co
.
9 4 2 8
0 5 8 2 9 9 4 2 8
m
Cursors on Front Panel of DTR-8.8
DTR-8.8
9 9
9 9