Adjusting The Brake Pedal - Toro 07383 Operator's Manual

Figure 57
1. Knob
2. Set screw
3. Rotate the knob (Figure
to 22 kg (45 to 50 lb) is required to actuate the
lever.
4. Tighten the set screw when finished
Note:
If you can no longer make a parking-brake
adjustment by adjusting the parking-brake
lever, loosen the handle to the middle of the
adjustment and adjust the cable at the rear, then
repeat step 3.
5. Install the rubber grip onto the parking-brake
lever (Figure 56).
g033488
3. Parking-brake lever
57) until a force of 20
(Figure 57).

Adjusting the Brake Pedal

Service Interval: Every 200 hours
Note:
Remove the font hood to ease the adjustment
procedure.
1. Remove the cotter pin and clevis pin securing
the master cylinder yoke to the brake-pedal
pivot (Figure 58).
1. Master cylinder yoke
2. Lift up on the brake pedal
contacts the frame.
3. Loosen the jam nuts securing the yoke to the
master cylinder shaft
4. Adjust the yoke until its holes align with the hole
in the brake-pedal pivot.
5. Secure the yoke to the pedal pivot with the clevis
pin and cotter pin.
6. Tighten the jam nuts securing the yoke to the
master cylinder shaft.
Note:
The brake master cylinder must relieve
pressure when properly adjusted.
53
Figure 58
2. Brake-pedal pivot
(Figure 59) until it
(Figure 59).
g002417