Adjusting the Brake Pedal
Service Interval: Every 200 hours
Note:
Remove the font hood to ease the adjustment
procedure.
1.
Remove the cotter pin and clevis pin securing
the master cylinder yoke to the brake-pedal
pivot
(Figure
61).
Figure 61
1. Master cylinder yoke
2.
Lift up on the brake pedal
contacts the frame.
3.
Loosen the jam nuts securing the yoke to the
master cylinder shaft
4.
Adjust the yoke until its holes align with the hole
in the brake-pedal pivot.
5.
Secure the yoke to the pedal pivot with the clevis
pin and cotter pin.
6.
Tighten the jam nuts securing the yoke to the
master cylinder shaft.
Note:
The brake master cylinder must relieve
pressure when properly adjusted.
2. Brake-pedal pivot
(Figure
62) until it
(Figure
62).
1. Clutch pedal
2. Brake pedal
g002417
53
Figure 62
3. Accelerator pedal
g036549