Adjusting The High-Low Cable; Adjusting Differential-Lock Cable; Inspecting The Tires - Toro Workman HDX Series Operator's Manual

Adjusting the High-Low
Cable
Service Interval: Every 200 hours
1. Remove the clevis pin securing the high-low
cable to the transaxle
2. Loosen the clevis jam nut and adjust the clevis
so that the clevis hole aligns with the hole in the
transaxle bracket.
3. Install the clevis pin and tighten the jam nut
when finished.
Adjusting Differential-Lock
Cable
Service Interval: Every 200 hours
1. Move the differential-lock lever to the O
position.
2. Loosen the jam nuts securing the differential-lock
cable to the bracket on the transaxle
Figure 47
1. Differential-lock cable
2. Transaxle bracket
3. Adjust the jam nuts to obtain a 0.25 to 1.5 mm
(0.01 to 0.06 inch) gap between the spring hook
and the OD of the hole in the transaxle lever.
4. Tighten the jam nuts when finished.
(Figure 46).
FF
(Figure 47).
g002425
3. Spring
4. 0.25 to 1.5 mm (0.01 to
0.06 inch) gap

Inspecting the Tires

Service Interval: Every 100 hours
Front tires air pressure specification: 220 kPa (32
psi)
Rear tires air pressure specification: 124 kPa (18
psi)
Operating accidents, such as hitting curbs, can
damage a tire or rim and also disrupt wheel alignment,
so inspect the tire condition after an accident.
Important:
Check the tire pressure frequently
to ensure proper inflation. If the tires are not
inflated to the correct pressure, the tires will wear
prematurely and may cause 4-wheel drive to bind.
Figure 48 is an example of tire wear caused by
under-inflation.
1. Under-inflated tire
Figure 49 is an example of tire wear caused by
over-inflation.
1. Over-inflated tire
46
Figure 48
Figure 49
g010294
g010293