Setup; Installing The Steering Wheel - Toro Workman MDX Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel
TC Models Only
Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel
2. Remove the locknut (1/2 inch) from the steering
shaft (Figure 3).
3. Slide the steering wheel and washer (1/2 inch)
onto the steering shaft
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 27 to 34 N∙m
(20 to 25 ft-lb).
Description
Steering wheel
Cover
Washer (1/2 inch)
No parts required
No parts required
No parts required
Operator's Manual
Engine owner's manual
Registration card
Predelivery Inspection Form
Certificate of Quality
Key
(Figure 3).
(Figure 3).
Qty.
1
Install the steering wheel (TC models
1
only).
1
–
Connect the battery (TC models only).
–
Check the fluid levels and tire pressure.
–
Burnish (break-in) the brakes.
1
1
Read the Operator's Manual and view
1
the setup material before operating the
1
machine.
1
2
5. Install the cover on the steering wheel
1. Cover
2. Locknut (1/2 inch)
3. Washer (1/2 inch)
9
Use
(Figure
Figure 3
4. Steering wheel
5. Steering shaft
3).
g033840