General Maintenance - Spirit XE795 Owner's Manual

Hide thumbs Also See for XE795:

Table of Contents

General Maintenance

1. Wipe down all areas in the sweat path with a damp cloth after each workout.

2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two

reasons:

I. The hardware was not sufficiently tightened during assembly. All bolts that were installed during

assembly need to be tightened as much as possible. It may be necessary to use a larger wrench

than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough;

90% of calls to the service

department for noise issues can be traced to loose hardware.

II. The crank arm nut needs to be retightened

III. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling

pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the

levelers.

ENGINEERING MODE MENU

The console has built in maintenance/diagnostic software. The software will allow you to change the

console settings from English to Metric and turn off the beeping of the speaker when a key is pressed

for example. To enter the Engineering Mode Menu, press and hold down the Start, Stop and Enter

keys. Keep holding the keys down for about 5 seconds and

the Message Center will display Engineering Mode Menu. Press the Enter key to access the menu

below:

a. Key Test (Will allow you to test all the keys to make sure they are functioning)

b. LCD Test (Tests all the display functions)

c. Functions (Press Enter to access settings and Up arrow to scroll)

I. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of

inactivity)

II. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)

III. ODO Reset (Resets the odometer)

IV. Units (Sets the display to readout in English or Metric display measurements)

V. Beep (Turns off the speaker so no beeping sound is heard)

VI. DA Test (Tests the brake resistance)

Security (Allows the keypad to be locked to prevent unauthorized use)

Table of Contents