General Maintenance - Spirit XG400 Owner's Manual

GENERAL MAINTENANCE

1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of several
reasons:
i. The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger
wrench than the one provided if you cannot tighten the bolts sufficiently. I cannot stress this
point enough; 90% of calls to the service department for noise issues can be traced to loose
hardware.
ii. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from
build-up on the rails can cause a thumping sound that you would swear is coming from inside
the main body of the machine because noise travels, and is amplified, in the tubing of the frame.
Clean the rails and wheels with a lint free cloth and rubbing alcohol. Stubborn build-up can be
removed with your thumbnail or a nonmetallic scraper, like the back edge of a plastic knife. After
cleaning, apply a small amount of lubricant on the rails with your fingers or a lint free cloth. You
only need a thin coat of lubrication, wipe off any excess.
iii. The crank arm nut needs to be retightened
iv. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the bottom of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust
the levelers.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed for
example. To enter the Engineering Mode Menu, press and hold down the Start, Stop and Enter keys.
Keep holding the keys down for about 5 seconds and the message center will display Engineering Mode
Menu. Press the Enter button to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. LCD Test (Tests all the display functions)
3. Functions (Press Enter to access settings and Up arrow to scroll)
i. Display Mode (Turn
inactivity)
ii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
iii. ODO Reset (Resets the odometer)
iv. Units (Sets the display to readout in English or Metric display measurements)
v. Beep (Turns off the speaker so no beeping sound is heard)
vi. Motor Test
vii. Safety
4. Security (Allows the keypad to be locked to prevent unauthorized use)
off to have the console power down automatically after 20 minutes of
26