Table of Contents
Advertisement
a.
Key test(will allow you to test all the keys to make sure they are functioning)
b.
Display test (tests all the display functions)
c.
Functions (Press enter to access settings)
i.
Sleep mode (Turn on to have the console power down automatically after 30 minutes of inactivity)
ii.
Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
iii.
ODO reset (reset the odometer)
iv.
Units (Set to English or Metric display readings)
v.
Beep (Turn on or off the beep when a key is pressed)
vi. D/A test (tests the brake resistance)
vii. SAFETY
d.
Security (Allows you to lock the keypad so no unauthorized use is allowed)
Stride Calibration: If there is a problem with the stride, try running the calibration. Press the Start key and
Level up key at the same time. Hold them down for 5 seconds and the stride calibration, press Enter and run
automatically. If the problem persists, contact service department.
GENERAL MAINTENANCE
8.
Wipe down all areas in the sweat path with a damp cloth after each workout.
9.
If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:
I.
The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a larger wrench than the
one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough; 90% of calls to the ser-
vice department for noise issues can be traced to loose hardware.
II.
The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling pads on the bottom
34
of the rear stabilizer, use a 14mm wrench (or adjustable wrench) to adjust the levelers.
Advertisement
Table of Contents
