Spirit XE795 Owner's Manual page 7

STEP 1
1. Gather HARDWARE FOR STEP 1.
2. Tilt the elliptical trainer to one side (you may want to place a piece of Styrofoam or a block under the
unit for support). Install the 3 LEVELERS (81) to the underside of the unit. Repeat this
assembly on opposite side of the unit.
3. Press the 6 END CAPS (82) into the oval stabilizer tubes.
4. Attach the TRANSPORT WHEELS (80) to each bracket with 2 BOLTS (92) and 2 NUTS (99).
Partially tighten with the 13/14mm WRENCH and 5mm L WRENCH. Over tightening the hardware
will prevent the wheels from rotating.
5. Attach the SLIDE WHEEL COVERS (45) with 4 SCREWS (55). Tighten with the screw driver.
NOTE: When assembly is complete, the transport wheels can be engaged by lifting the rear of the
elliptical trainer.
HARDWARE
#55. M5 × 10m/m
Phillips Head Screw
(4pcs)
#92. 5/16" ×1-3/4" Button
Head Socket Bolt
(2 pcs)
6
#99. 5/16"
Nyloc Nut
(2 pcs)
leveler