Table of Contents
Advertisement
General Maintenance
1.
Wipe down all areas in the sweat path with a damp cloth after each workout.
2.
If a squeak, thump, clicking or rough feeling develops the main cause is most likely one
of two reasons:
i.
The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. l cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware or the rear rails
being dirty.
ii.
Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.
Noise from build-up on the rails can cause a thumping sound that you would
swear is coming from inside the main body of the machine because noise travels,
and is amplified, in the tubing of the frame. Clean the rails and wheels with a lint
free cloth and rubbing alcohol. Stubborn build-up can be removed with your
thumbnail or a non-metallic scraper, like the back edge of a plastic knife. After
cleaning, apply a small amount of lubricant on the rails with your fingers or a lint
free cloth. You only need a thin coat of lubrication, wipe off any excess.
3.
If squeaks or other noises persist, check that the unit is properly leveled. There are 4
leveling pads on the bottom of the rear rails, use a 14mm wrench (or adjustable wrench)
to adjust the levelers.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to
change the console settings from English to Metric and turn off the beeping of the speaker
when a key is pressed for example. To enter the Engineering Mode Menu, press and hold
down the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds and
the message center will display Engineering Mode Menu. Press the Enter button to access
the menu below:
Key Test (Will allow you to test all the keys to make sure they are functioning)
a.
Security (Allows the keypad to be locked to prevent unauthorized use)
b.
Functions (Press Enter to access settings and Up arrow to scroll)
c.
Sleep Mode (Turn on to have the console power down automatically after 20
I.
minutes of inactivity)
Incline On/Off (For e•Glide this is always off)
II.
Unit Type (Should show Elliptical, other setting is e•Glide. Switches calorie
III.
formula, HR program settings and watt tables for the different units)
iv. Motor Test (Press Enter to run the resistance motor up and down in a
IV.
continuous loop. Display shows level setting and position sensor reading. Press
Stop to end test.)
Beep (Turns off the speaker so no beeping sound is heard)
V.
Units (Sets the display to readout in English or Metric display measurements)
VI.
ODO Reset (Resets the odometer)
VII.
Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console
VIII.
pause indefinitely)
LCD Test (Tests all the display functions)
d.
CUSTOMER SERVICE 1-888-707-1880
26
Dyaco Canada Inc.©2013
Advertisement
Table of Contents
