Spirit XE795 Owner's Manual page 10

STEP 4
1. Gather HARDWARE FOR STEP 4.
2. Remove the foam from the console mast axles and the plastic ties from the swing arm tube.
3. The swing arms will be labeled "L" for left and "R" for right. Slide the LEFT SWING ARM (5) onto the
left console mast axle. The swing arms have been preassembled at the factory to assure a proper fit.
The fit will be snug. Please do not force the arm on the axle or use a hammer, as damage to the
bearings could occur.
4. Secure the swing arm to the mast with the BUSHING WASHER (51) and the SOCKET HEAD CAP
BOLT (89). Tighten with the 8mm L WRENCH.
5. Snap on the decorative BUSHING ROUND END CAP (79).
6. Repeat these steps on the right side.
HARDWARE
#51. M10
Bushing Washer
(2 pcs)
#89. M10 × 20m/m
Socket Head Cap Bolt
(2 pcs)
9