Table of Contents
Advertisement
General Maintenance
1.
Wipe down all areas in the sweat path with a damp cloth after each workout.
2.
If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the ser- vice
department for noise issues can be traced to loose hardware.
II.
The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled.
There are 2 leveling pads on the bottom of the rear stabilizer, use a 14mm
wrench (or adjustable wrench) to adjust the levelers.
ENGINEERING MODE
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed
for example. To enter the Maintenance menu (may be called Engineering mode, depending on
version) press and hold down the Start, Stop and Enter keys. Keep holding the keys down for about 5
seconds and the message window will display
Press the enter button to access the menu below:
a. Key test (will allow you to test all the keys to make sure they are functioning)
b. Display test (tests all the display functions)
c. Functions (Press enter to access settings)
vii. SAFETY
d. Security (Allows you to lock the keypad so no unauthorized use is allowed)
Stride Calibration: If there is a problem with the stride, try running the calibration. Press the Start key and
Level up key at the same time. Hold them down for 5 seconds and the stride calibration, press Enter and
run automatically. If the problem persists, contact service department.
i. Sleep mode (Turn on to have the console power down automatically after 30
minutes of inactivity)
ii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console
pause indefinitely)
iii. ODO reset (reset the odometer)
iv. Units (Set to English or Metric display readings)
v. Beep (Turn on or off the beep when a key is pressed)
vi. D/A test (tests the brake resistance)
"ENGINEERING MODE MENU PRESS
29
ENTER".
Advertisement
Table of Contents
