Omega Engineering OMB-NETSCAN 1500 User Manual page 95

Adding a Chart to Group 1
3. Change the number of charts per group if desired.
4. Change the group name if desired.
5. Click on a group to see the chart(s) assigned to the group. In the above example there is one group
with one chart.
6. Click on a chart to assign channels to the chart. A screen similar to the following will appear.
Assigning Channels to Chart 1 of Group 1
7. Choose channels for the selected chart. You can select up to 4 overlapping channels per chart. There
are four methods of adding channels. These are as follows:
•
Highlight an available channel using the cursor and left-hand mouse button; then click the Add button. Repeat for
•
Double-click on the channel (in the available channels list to add; in the selected channels list to remove)
•
Hold down the keyboard's Shift Key and use the left-hand mouse button to select a block of consecutive available
•
Hold down the keyboard's Ctrl button and use the left-hand mouse button to select up to 4 available channels
Example: CH1, CH3, CH5, and CH7, as in the previous figure.
NetScan User's Manual,
11-06-98
each channel to be added.
channels (up to 4); then click the Add button. Example: CH3, CH4, CH5,and CH6.
(these can be non-consecutive); then click the Add button.
PostView 5-13