Omega Engineering OMB-NETSCAN 1500 User Manual page 58

Automatic Keyboard
on Auto Re-arm
Acquire
Arm Acquisition
(Ctrl + T)
Disarm...
(Ctrl + Y)
Acquisition Status...
Start All Indicators
Stop All Indicators
Data
DDE Configuration for Excel...
4-20 ChartView Software Reference
Acquisition
(continued)
This feature works in conjunction with Keyboard Triggering when Auto Re-arm is being
Trigger used. Auto Re-arm is discussed on page 4-39.
If the option is disabled, acquisition data is saved to disk, and the device automatically
re-arms. ChartView displays the Trigger dialog box and waits for the trigger button to be
pressed by the user before beginning the next acquisition.
If the option is enabled (3), the trigger dialog box is not displayed and the trigger is
automatically sent to the acquisition device. The automatic trigger may be delayed by up
to 2 seconds (after the previous acquisition has finished).
Arms the data acquisition device in preparation of receiving a trigger.
Disarms the data acquisition device and discontinues the acquisition of data.
Displays the condition of a data acquisition.
Starts all selected indicators for: the spreadsheet Reading column, Charts, and Meters.
Stops all selected indicators for spreadsheet Reading column, Charts, and Meters.
Configures the DDE (Dynamic Data Exchange) operation of ChartView. This pull-
down menu allows you to dynamically load collected ChartView data into an open
Excel spreadsheet. The three field regions are: Command Characters, Data
Destination, and Timeout. These are discussed on the following page.
NetScan User's Manual