Table of Contents
Advertisement
The mode is selected from the lower left-hand portion of the dialog box. The following figure
represents a screen capture with normal mode selected.
The following figure depicts components of an acquisition. The Trigger and Stop Points represent the
entries described under the Event Configuration selection in the table on the following page.
In the "High-speed, single-channel" mode the Scan Intervals parameters section is replaced with a
High-Speed Setup parameters section with boxes for selection of Channel and Scan Rate, as indicated
in the following figure.
Note:
NetScan User's Manual
Acquisition Setup Dialog Box, Normal Mode
In the High-speed, single-channel (burst mode) all ChartView display functions are
intentionally disabled. Data acquisition and storage to disk are the only services that remain
functional. When you select the High-speed, single channel mode, a Warning dialog box
appears with this information, providing you with the opportunity to cancel if desired.
ChartView Software Reference
4-37
Advertisement
Chapters
Table of Contents
