Omega Engineering OMB-NETSCAN 1500 User Manual page 56

Display config.
Start
Stop
Pause
Next Group Ctrl+G
Faster
Slower
Zoom
[ Restore ]
Grid limit lines
Off
Solid Ctrl+F2
Dots
Timestamp
Absolute Ctrl+F4
Relative
View
Toolbar
Timestamps &
Chartspeed
Statusbar
4-18 ChartView Software Reference
Allows you to: Open a previously saved display configuration file, save the current
display configuration file, or save the current display configuration file in a different
location (or under a different file name). (See following note).
Note: There will be no default Display Configuration file present the first time ChartView is
started. In this case, Chart Setup Wizard activates, allowing you to create a display
setup. When ChartView is shutdown, the display configuration is automatically saved in
a default configuration file that will load upon the next startup of ChartView.
If the default display configuration becomes corrupt, or if you would like to bypass this
configuration when starting ChartView, you can hold down the Control Key when
starting ChartView. This causes the program to ignore the default display configuration
and await your creation of a new display.
F5 Starts, stops, or pauses chart scrolling.
F6
F7
Selects the next chart group in the display configuration.
Used to alter the chart scrolling speed. There are fourteen possible chart speeds. The
Ctrl+Z
range of speeds is from 0.1 sec/div to 1.0 hr/div.
Ctrl+X
Zoom causes the Main Window to display one chart only. For example, if you were
viewing 3 charts and desired to get a better view of Chart 2, you could use Zoom to
view Chart 2 using the full chart viewing area, as compared to using one third of the
area. The zoom feature can also be invoked by double-clicking in the chart region of
the chart you want to apply the zoom to.
Once you have zoomed in on a chart, the pull-down menu Zoom option is replaced by a
Restore option. Selecting Restore from the menu will return the main window to its
previous multiple chart viewing status. The restore feature can also be invoked by
again double-clicking in the chart region.
Allows you to turn the chart's grid limit lines (items 13 & 19) on or off. If "on", you can
have the grid lines appear as solid or dots.
Ctrl+F1
Ctrl+F3
Allows you to select an Absolute or Relative style of timestamp.
Ctrl+F5
A by Toolbar indicates the toolbar will be visible. The absence of the
visible toolbar option is not chosen, and in this case will not appear on the Main Window.
Use the mouse to select or de-select the toolbar option.
A by Timestamps & Chartspeed indicates the options are selectable and visible. The
absence of the
not visible on the Main Window. Use the mouse to select or de-select this option.
A by Statusbar indicates the Status Message Box and Status LEDs are visible (items
22 and 24, page 4-5). The absence of the
on the Main Window. Use the mouse to select or de-select this option.
indicates the timestamp/chartspeed option is not chosen, and therefor
indicates the
indicates the status bar will not be visible
NetScan User's Manual